Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - pabloantxon

Pages: [1]
Hardware Questions / Re: 3d print enclosure for Glo V1
« on: January 12, 2023, 12:17:44 PM »
Hey Mario!
Try now, maybe I forgot to publish it. Ive done it now, I hope it works :)

Hardware Questions / 3d print enclosure for Glo V1
« on: January 12, 2023, 09:37:16 AM »
Hey there, I made an enclosure for this wonderful piece of hardware, after having it naked for years.
You can download it for 3d printing here:
You can also download the stls for the board and the rubber button thing so you can make your own enclosure in case you rather doing that.
Enjoy!  :)

Hardware Questions / Re: Questions about adding line in to DIY Glo
« on: May 17, 2019, 12:33:16 PM »

Great, I'll use 220nF caps then :)

About the firmware, is it open source? Have you uploaded it somewhere? I would like to take a look at it. If it is not don't worry, I understand you are very busy right now sending all the glos and working on the gecho v2.

I am interested in that board, I wrote you an email to gechologic at gmail dot com :)

Thanks for your reply!


Hardware Questions / Questions about adding line in to DIY Glo
« on: May 10, 2019, 11:37:43 AM »
I received my DIY Glo two days ago and I'm loving it, it makes just typing at work a relaxing experience. I don't know about further experiments, but the way it already works as it came it is perfect :)

I'm looking at adding a line input to see what comes out of it when I connect my synths and stuff.
I've seen in the Hardware Extensions section ( ) that you can solder a line input to MIC2 L and R pads and I have a question.
I guess the tip and the ring of the mini jack go to the L and R pads, but what about the sleeve? Should it go to the AGND pad?

And another question:
If I add the line input, will I be able to choose the board microphones or the line input as the audio input, or will both work at the same time unless I change it in the software?

Hardware Questions / Re: Duration of Lipo batteries
« on: May 08, 2019, 01:08:27 PM »

I guess I'll be getting a 500 mah battery then, I really don't think I'll need 20 hours and the 500 mah one measures 3.5 x 2.5 cm, which will fit better and still give me plenty juice for any experimentation.

Thanks a lot for your quick reply!!! :)))

Hardware Questions / Duration of Lipo batteries
« on: May 07, 2019, 01:30:24 PM »
I'm expecting my DIY Glo to arrive any day now, and I have started searching lipo batteries to attach to it.
Looking at the dimensions of the Glo board (about 8 x 3.5 cm) I have found a 1200 mah 3.3v lipo battery that measures 5.2 x 3.5 cm and it seems to be fine for the task (actually 8 x 3.5 is the dimensions of the wooden whale, I guess the board is smaller).
My question is, do you have an estimate of how long should a fully charged battery last? I mean the charge cycle, not the full battery life. How many minutes / hours / whatever.
I see you a 250 mah battery on the tutorial for soldering the components, so maybe 1200 mah would be overkill?

Pages: [1]